Minor patch for the VSR/Railsim.co.uk Signalling pack, version 1.1. Includes the missing possession Limit board, and fixes a bug with signal 3AT offset LHS.

Download v1.11

VSR / Railsim.co.uk Signalling Pack, version 1.1.

The long awaited update to the original VSR signalling pack.

Post mounted signals are now available with electrification earth grids on one or both sides, and with offset heads.

Terminating signals are now available in three different head types.

Three different theatre indicators are now included - configured using similar targets to the feathers, and allowing display of a single character (including numbers up to 19), a two digit number up to 99, or two arbitrary characters. All signals are theatre aware and can use the new theatre indicators, including signals previously released in the v1.0 pack.

An update to the previously available banner repeater pack is included.

Finally, a Possession Limit board which acts as both a danger target and a red signal is included - handy for keeping the AI's out of areas you're currently working on.

Download v1.1

VSR / Railsim.co.uk Signalling and Directional Speedsign Pack, version 1.0.

At long last, here it is. Version 1.0 of the VSR/Rail-sim Signalling pack.

The initial release contains BR standard post mounted signals in 3 and 4 aspect, on both the Left and Right hand side of the track. Also included are some Southern Railway Reinforced Concrete single post cantilevers, and some BR steel cantlievers based on a design used in the Southern Region, but probably applicable to all diesel or 3rd rail areas.

Also included are a set of BR white/red circular speedboards, for plain line and for diverging routes, to the left, right, or both.

The junction directions (and speedboard diverging routes) are configured by a common system of markers - the signals will learn (in surveyor) which feathers they need, and remember this in a driver session. The markers should be fairly straightforward to figure out - see this thread on the UKTrainz forum for a basic guide. A document on usage will appear here at some point in the future.

The speedboards also read these markers, and will impose speed limits as appropriate.

Download v1

UK Limited Clearance signs. Use this where there is limited clearance between a structure and the track - not enough for a trackworker to stand clear. Commonly found on bridge abutments and along retaining walls. Also includes a sign with post for viaduct railings where it is not possible to put the sign directly on to the structure.

v1.2 adds the blue 'No Refuges' variant, for when there is limited clearance on only one side of the line, the other side of the track has sufficient clearance, and thus no refuge points have been provided on the side with tight clearances.

Note to all those who downloaded the 1.0 release, Sorry, but I didn't pay enough attention to the config on that one - it has a KUID clash with one of the 3rd rail ends. You will need to remove the folder "KUID 60850 23000" from the dispatcher/downloads folder by hand - and if you were using the 3rd rail pack, reinstall that.

Download v1.2